SZ-180高性能漆包线剥漆机

The SZ-180 high-performance enameled wire stripping machine adopts a newly designed extra-hard high-speed stripping cutter head, which can completely remove any hard insulating enamel, enamel, ML, lsonel, etc. from the wire surface without damaging the copper wire itself.It is especially suitable for situations where paint needs to be stripped down to the bottom of the coil. Easy to operate with excellent results. The SZ-180 enameled wire stripping machine is equipped with a stripping length stop device, which can accurately control the stripping length of the enameled wire and automatically adjust the curvature of the wire. With no serious pollution or hazards, the stripping work is fast and safe.

Specifications

Installation and Operation

Select a suitable cutter head and install it on the chuck at the front of the machine. Insert an enameled wire into the center of the cutter head, and use the fixing wrench to adjust the chuck so that the cutter head gently clamps the wire. Then withdraw the wire, activate the switch, hold the coil part by hand, and gently push the enameled wire into the high-speed rotating cutter head until it reaches the preset stripping length. Then carefully withdraw the wire, and the stripping work is complete. If necessary, the opening of the cutter head can be adjusted by loosening and tightening the chuck to achieve the ideal stripping effect. When the machine is running and the cutter head rotates at high speed, the insulating enamel or oxide on the enameled wire is removed, and the surface of the stripped enameled wire is bright and clean.

To set the required stripping length, loosen the fixing screw of the chuck and withdraw the chuck to reveal the stripping length limit pin. Adjust the limit pin with the fixing screw to set and control the stripping length of the enameled wire.