SZ-180A漆包线剥漆机|漆包线刮漆机采用目前台湾先进的电动刮漆技术, 能调节刮漆长度, 适应各种Specifications的漆包线, 应用方便自如, 能快速地刮漆包线的绝缘漆膜, 去污干净, 表面光洁. With superior performance, it completely replaces traditional paint removal methods such as manual knife scraping, grinding wheel and sandpaper grinding, and chemical corrosion, not only greatly improving work efficiency but also providing excellent solderability.It is ideal enameled wire paint scraping equipment for coil manufacturing and repair industries such as motors, electrical appliances, instruments, transformers, electronics, household appliances and power tools.It integrates an electronic stepless speed regulator, a motor and paint scraping blades in one unit, and adopts a lightweight and durable micro switch.It features fast paint scraping speed, high efficiency, simple operation, stable performance, low failure rate and a novel and practical design.(Several times more efficient than ordinary models)
Specifications
| Machine Model | SZ-180A去漆机 | Applicable Wire Diameter | 0．4－4．00mm |
| Machine Size | 255 x 180 x 180mm | Operating Voltage | 220v/50Hz |
| Motor Power | 120w | Speed | 0--4000r/min无级调速 |
| Machine Weight | 8.0kg | Optional Accessories | 合金刀片 |
| Stripping Length | 3－50mm | 品 牌 | AOLITE |
Installation and Operation
Select a suitable cutter head and install it on the chuck at the front of the machine. Insert an enameled wire into the center of the cutter head, and use the fixing wrench to adjust the chuck so that the cutter head gently clamps the wire. Then withdraw the wire, activate the switch, hold the coil part by hand, and gently push the enameled wire into the high-speed rotating cutter head until it reaches the preset stripping length. Then carefully withdraw the wire, and the stripping work is complete. If necessary, the opening of the cutter head can be adjusted by loosening and tightening the chuck to achieve the ideal stripping effect. When the machine is running and the cutter head rotates at high speed, the insulating enamel or oxide on the enameled wire is removed, and the surface of the stripped enameled wire is bright and clean.
To set the required stripping length, loosen the fixing screw of the chuck and withdraw the chuck to reveal the stripping length limit pin. Adjust the limit pin with the fixing screw to set and control the stripping length of the enameled wire.
